Scroll To Top
Toggle Menu

Spyder RT Wraps

F3

ORDERING PAGE - FOR PROCESSING SPYDER FRUNK WRAPS ONLY

Processed onto Premium 3M or Arlon Wrap Media.

FRUNK VERSIONS

Frunk wraps are one solid seamless panel. Typical early RT model has a package size of 36" inches.

  • image

Installation

Wrap media is engineered to be applied dry, rather than wet like most other applications. If you are unsure, please research dry application methods before starting.

 

Preparing Surface For Install

Clean with soap and water, then dry thoroughly Be sure to get under the frunk edges as well, for some panels are oversized so that you can wrap over the edge and onto the underside - then trim it off as desired.

*Clean surface one last time with rubbing alcohol when you're ready to start the installation.

 

How Long Does It Take To Install?

A professional will require about 1 to 1.5 hrs.

Doing it on your own may take approximately 1.5 to 2 hrs.

However, we highly recommend professional installation for a top notch look without flaws.

 

Where can I find an Installer?

You may wish to contact a local sign shop for assistance on the installation, as they generally have a staff member who has experience with this high-performance media. And always get at least two quotes before committing.

 

Protection After Install

Spray-on protective finishes are best, and easiest to work with - as it takes mere seconds to treat your new frunk wrap.

 

Can I Clean With A Power Washer?

It is not advised; as the frunk area is a small surface and easy to do by hand.

And if you happen to get tree sap on the surface, or road grime in bad weather, a protective sealer would add a barrier which makes clean-ups easy. Never try to remove sap with a power washer as it can and may blow a portion of the clear laminate off of the surface due to the high pressure - and in close proximity.

Tree sap is best removed promptly before it solidifies.

 

What if I Get A Stone Chip?

If you're unlucky and happen to get a stone chip some day, don't worry. Simply clean the area with rubbing alcohol, and apply a dab of clear nail polish, and you'll be good to go.

 

What if I someday Want To Remove The Wrap?

Wraps are easily removed by applying heat.

A paint stripper gun or hot hair dryer will be enough to soften the adhesive while pulling on the material. Same would apply on a hot summer day.

If any adhesive is left behind, clean-up is easy with just rubbing alcohol and a soft cloth.

ORDER BELOW

Select